LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 439 (Exterior Trim) >> Removal And Installation >> Radiator Grille Opening Panel

Radiator Grille Opening Panel

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the front bumper cover. For additional information, refer to FRONT BUMPER .
  2. Remove the components in the order listed in the following illustration and table.
    Fig 1: Removing Radiator Grille Opening Panel Components
    G03203569Courtesy of FORD MOTOR CO.
  3. To install, reverse the removal procedure.

Item 1: Wiring Harness Removal Note 

  1. Release the wiring harness locators and position the harness aside.

Item 4: Radiator Grille Opening Panel Removal Note 

  1. Release the ambient air temperature sensor.
    Fig 2: Releasing Ambient Air Temperature Sensor
    G03203570Courtesy of FORD MOTOR CO.