Instrument Cluster

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.

NOTE: Prior to removal of the module, it is necessary to upload module configuration information to the diagnostic tool. This information needs to be downloaded into the new module once installed. For additional information, refer to MODULE COMMUNICATIONS NETWORK .

NOTE: If either the instrument cluster or the powertrain control module (PCM) are installed, update or configured, both modules will require a parameter reset to allow both modules to recognize the passive anti-theft system (PATS) keys.

Failure to carry out the parameter reset to both the instrument cluster and the PCM may result in a no start condition.

Tilt the steering column to the lowest position and telescope (extend) the steering column to the farthest position.
Depower the supplemental restraint system (SRS). For additional information, refer to AIR BAG RESTRAINT SYSTEMS .
Remove the instrument panel cluster finish panel. For additional information, refer to INTERIOR TRIM .
Remove the lower instrument panel steering column reinforcement. For additional information, refer to INTERIOR TRIM .
Remove the parts in the order indicated in the following illustration and table.

Fig 1: Identifying Removing Sequence Of Instrument Cluster
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.

Item 4: Steering Column Nuts Removal Note

Loosen but do not remove the steering column nuts.

Item 6: Instrument Cluster Electrical Connectors Removal Note

CAUTION: To avoid damage to the instrument cluster lens, place a protective cloth over the upper steering column before removing the instrument cluster.

Pull the instrument cluster out from the instrument panel and disconnect the electrical connectors.

Item 7: Instrument Cluster Installation Note

CAUTION: To avoid damage to the instrument cluster lens, place a protective cloth over the upper steering column before installing the instrument cluster.

CAUTION: Once the new module is installed, it is necessary to download the module configuration information from the diagnostic tool into the new module. For additional information, refer to MODULE COMMUNICATIONS NETWORK .

Following installation of the instrument cluster, carry out the Parameter Reset and Key Programming procedure.
The parameter reset must also be carried out for the PCM. For additional PCM information, refer to ENGINE CONTROLS - POWERTRAIN DTC CHARTS & DESCRIPTIONS - CNG, FLEX-FUEL & GASOLINE article in ENGINE PERFORMANCE .