Camshaft Position (CMP) Sensor

WARNING: This page is about a different car, the 2004 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the battery ground cable.
If removing the LH camshaft position (CMP) sensor, remove the air cleaner assembly. For additional information, refer to AIR CLEANER ASSEMBLY in this section.
If removing the LH CMP sensor, remove the throttle body. For additional information, refer to THROTTLE BODY in this section.
Remove the retainer from the fuel line bracket and position the fuel rail aside.

Remove the components in the order indicated in the following illustration and table. See Fig 1. To remove individual components, carry out only the listed steps. See COMPONENT CHART .

COMPONENT CHART

Component	Steps
RH camshaft position (CMP) sensor	1-6
LH CMP sensor	7-10

To install, reverse the removal procedure.

Fig 1: Removing Camshaft Position (CMP) Sensor
Courtesy of FORD MOTOR CO.

Item 8: LH CMP Electrical Connector Removal Note

Remove the fuel hose bracket bolt.

Fig 2: Removing Fuel Hose Bracket Bolt
Courtesy of FORD MOTOR CO.

Item 8: LH CMP Electrical Connector Installation Note

Install the fuel hose bracket bolt.

Fig 3: Installing Fuel Hose Bracket Bolt
Courtesy of FORD MOTOR CO.