LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 383 (Rear Drive Axle/Differential 7.5-Inch Ring Gear) >> In-Vehicle Repair >> Drive Pinion Seal >> Installation

Drive Pinion Seal: Installation

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Lubricate the new rear axle drive pinion seal with grease.
    2. CAUTION: If the rear axle drive pinion seal becomes misaligned during installation, remove the rear axle drive pinion seal and install a new seal.
    Fig 1: Installing Rear Axle Drive Pinion Seal
    G03434211Courtesy of FORD MOTOR CO.
  2. Using the special tool, install the rear axle drive pinion seal.
  3. Install the pinion flange. For additional information, refer to DRIVE PINION FLANGE  .
scientia non olet · About LEMON Manuals