LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 383 (Rear Drive Axle/Differential 7.5-Inch Ring Gear) >> In-Vehicle Repair >> Differential Housing Cover >> Removal

Differential Housing Cover: Removal

WARNING: This page is about a different car, the 2002 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. For additional information, refer to BATTERY, MOUNTING AND CABLES .
    2. NOTE: Empty the lubricant into a clean container for reuse.
    Fig 1: Removing Differential Housing Cover
    G03434212Courtesy of FORD MOTOR CO.
  2. Remove the differential housing cover.
    1. Remove the 10 differential housing cover bolts and drain the lubricant from the rear axle housing.
    2. Remove the differential housing cover.
scientia non olet · About LEMON Manuals