LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2676 (Wiper System & Washer System) >> Description And Operation >> Diagnosis And Testing >> Principles of Operation >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2011 Mercury Milan, 2011 Lincoln MKZ, and 2011 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical and electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Wiper linkage
    • Washer nozzles
    • Washer pump hoses
    • Washer reservoir
    • Wiper pivot shaft mounting
    • Wiper blades
    • Battery Junction Box (BJB) fuse 9 (20A)
    • Smart Junction Box (SJB) fuse 45 (5A)
    • Multifunction switch
    • Wiper motor
    • Washer pump
    • Rain sensor
    • Wiper/washer module
    • Loose or corroded connections
    • Wiring harness
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. NOTE: The wiper/washer module does not communicate on the network.
  5. If the cause is not visually evident, connect the scan tool to the Data Link Connector (DLC).
  6. NOTE: The Vehicle Communication Module (VCM) LED prove out confirms power and ground from the DLC are provided to the VCM.
  7. If the scan tool does not communicate with the VCM:
  8. If the scan tool does not communicate with the vehicle:
  9. Carry out the network test.
  10. Clear the CMDTCs and carry out the self-test diagnostics for the SJB.
  11. If the DTCs retrieved are related to the concern, go to SMART JUNCTION BOX (SJB) DTC CHART . For all other DTCs, refer to MULTIFUNCTION ELECTRONIC MODULES -- FUSION, MILAN & MKZ article.
  12. If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .