LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Engine - 4.6L V8 - VIN W & 6) >> Removal & Installation >> Engine >> Installation (All Models)

Installation (All Models)

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2001 Ford Pickup, 2001 Ford Expedition, 2001 Ford Econoline, 2000 Ford Pickup, and 2000 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Tighten all bolts to specification. See TORQUE SPECIFICATIONS .
  2. When installing fuel lines, fit NEW fuel resistant "O" rings (Brown) on fuel lines. Lightly coat "O" rings with clean engine oil before installing. Clean fittings, and replace garter spring (if necessary).
  3. Adjust all control cables and fluid levels. Refill cooling system. Evacuate and recharge A/C system.
scientia non olet · About LEMON Manuals