LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Engine - 4.6L V8 - VIN W & 6) >> Removal & Installation >> Camshaft >> Installation

Removal & Installation: Camshaft: Installation

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2001 Ford Pickup, 2001 Ford Expedition, 2001 Ford Econoline, 2000 Ford Pickup, and 2000 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
    CAUTION: Ensure proper procedure is used when installing timing chains to prevent engine damage. See TIMING CHAINS .
  1. Coat components with engine oil, and install components. Install all bolts for both camshaft caps, and tighten them finger tight. Tighten bolts to 72-106 INCH lbs. (8-12 N.m) in sequence. See Fig 1. Loosen all bolts 2 turns. Retighten bolts to 72-106 INCH lbs. (8-12 N.m) in sequence. Repeat procedure for each camshaft.
  2. Ensure camshaft end play is within specification. See CAMSHAFT  table under ENGINE SPECIFICATIONS. To install remaining components, reverse removal procedure. Tighten all bolts to specification. See TORQUE SPECIFICATIONS .
Fig 1: Camshaft Cap Bolt Tightening Sequence
G97D03651Courtesy of FORD MOTOR CO.
Fig 2: Removing Camshaft Caps (Romeo Engine)
G91G07212Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals