LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 25 (Engine - 4.6L V8 - VIN W & 6) >> Overhaul >> Cylinder Block Assembly >> Rod Bearings

Rod Bearings

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2001 Ford Pickup, 2001 Ford Expedition, 2001 Ford Econoline, 2000 Ford Pickup, and 2000 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Mark connecting rod and cap for reassembly reference. Components are not marked at factory. Install NEW bolts in connecting rods.
  1. Ensure piston and connecting rod are installed in engine with notch on top of piston toward front of engine. See Figure or Figure .
  2. Check bearing clearances using Plastigage method. Ensure bearing oil clearance and side play are within specification. See CRANKSHAFT, MAIN & CONNECTING ROD BEARINGS  and CONNECTING RODS  tables under ENGINE SPECIFICATIONS. If oil clearance exceeds specification, grind crankshaft to fit .010" (.25 mm) undersize bearings. Tighten connecting rod bearing cap bolts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals