LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2457 (Anti-Theft System - Passive Anti-Theft System (Pats) - (Hybrid)) >> General Procedures >> Spare Key Programming - Using Diagnostic Equipment >> Special Tool(s)

Special Tool(s)

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
SPECIAL TOOL DESCRIPTION CHART

G06064936Courtesy of FORD MOTOR CO.
 Vehicle Communication Module (VCM) and Integrated Diagnostic System (IDS) software with appropriate hardware, or equivalent scan tool
NOTE: This procedure is used when a customer needs to have an additional key programmed into the vehicle without erasing stored key codes, but does not have 2 programmed keys available. This procedure is also useful when attempting to determine if an ignition key is defective, as a new key can be programmed without erasing keys or without having 2 programmed keys available.
NOTE: Before programming, the new key must have the correct mechanical cut for the ignition lock cylinder.
NOTE: If 8 keys are already programmed, this procedure does not allow any more ignition keys to be programmed. The number of keys that are programmed into the Passive Anti-Theft System (PATS) can be determined by viewing the Instrument Cluster (IC) PID N_KEYCODE.
  1. Turn the new key to be programmed from the OFF position to the ON position.
  2. From the scan tool, enter TOOLBOX. Select: BODY - SECURITY - PATS Functions and follow the Integrated Diagnostic System (IDS) on-screen instructions to ENTER SECURITY ACCESS. For additional information, refer to ANTI-THEFT SECURITY ACCESS .
    3. NOTE: Make sure the selection made is "Program additional ignition key". If the "Ignition Key Code Erase" selection is made, all of the keys will be erased from the system.
  3. From the scan tool menu select: "Program additional ignition key".
    4. NOTE: The 20-second delay is to allow sufficient time for the module to exit its diagnostic mode.
  4. Turn the key to the OFF position and disconnect the scan tool (wait 20 seconds).
  5. Start the vehicle with the new PATS  key. The vehicle will now start with the new PATS  key and also with the original PATS  keys. If it is an IKT  key, verify the RKE  functions (if there are 4 or fewer IKT  keys programmed).
scientia non olet · About LEMON Manuals