LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2457 (Anti-Theft System - Passive Anti-Theft System (Pats) - (Hybrid)) >> General Procedures >> MyKey™ Programming >> Disable MyKey™ Restricted Features

Disable MyKey™ Restricted Features

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: This procedure is used to disable the MyKey™ feature on all of the keys that are programmed to the vehicle. All of the keys then operate as normal (admin) keys with no restrictions.
  1. Insert an admin key into the ignition lock cylinder and turn the key to the ON position.
  2. Press SETUP until PRESS RESET TO CLEAR MYKEY appears.
  3. Press and hold RESET until HOLD RESET TO CONFIRM CLEAR and ALL KEYS ARE CLEARED is displayed.
    • A MyKey™ can also be cleared during the same key cycle that it was programmed by following Steps  2 and  3 of this procedure.
scientia non olet · About LEMON Manuals