Configuring MyKey™ Optional Restricted Features

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: The following features can be restricted on a MyKey™:

audio volume level set to a pre-determined level (45% of the maximum volume)
maximum speed limit of 130 km/h (80 mph) on or off
speed alert chimes set for 75, or 90 or 105 km/h (45, or 55 or 65 mph)
AdvanceTrac® always on feature turned on or off

NOTE: If programming or configuring a MyKey™, but then decide to clear the key instead, do not turn the key to the OFF position. Follow the Disable MyKey™ Restricted Features procedure in this article to clear the key of any restricted MyKey™ status. If necessary, refer to MYKEY(TM) for MyKey™ system checks and system warnings displays.

To configure the MyKey™ optional restricted features listed directly above, carry out the following:
1. Using an admin key that has not been programmed as a MyKey™, turn the key to the ON position.
2. Press and hold the SETUP button until RESET FOR MYKEY SETUP is displayed.
3. Press and release the RESET button to display the MyKey™ setup menus. The first programmable feature is: MYKEY MAX MPH OFF.
  - To change the status of a feature that appears, press SETUP to accept the current setting and the message center displays the next feature.
  - To change the status of the feature that is displayed, press RESET to turn a feature on/off (or toggle between choices). After the feature selection has been made, press and release SETUP to accept and the message center displays the next feature.
4. Repeat the process for the next features:
  - MYKEY MPH TONES 45 55 65 (choose the desired speed for the chime to sound)
  - MYKEY VOLUME LIMIT OFF (choose the audio volume to be limited to 45%)
  - MYKEY ADVTRAC CTRL ON (choose for the AdvanceTrac® to be automatically locked on or able to be turned on or off by the MyKey™ driver)