LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2433 (Front Disc Brake System) >> Removal And Installation >> Front Brake Caliper Anchor Plate >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Mariner and 2010 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wheel and tire. For additional information, refer to WHEEL AND TIRE .
    2. NOTE: Do not allow the caliper to hang from the brake hose or damage to the hose can occur.
  2. Remove the 2 brake caliper guide pin bolts and position the caliper aside.
    • Support the caliper using mechanic's wire.
  3. Remove the 2 brake caliper anchor plate bolts.
    • To install, tighten to 175 Nm (129 lb-ft).
  4. Remove the brake caliper anchor plate.
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals