LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2354 (Wiper System & Washer System) >> Removal And Installation >> Wiper Motor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the wiper pivot arms. For additional information, refer to Removal and Installation .
  2. Remove the windshield wiper mounting arm and pivot shaft. For additional information, refer to Removal and Installation .
  3. Separate the wiper motor linkage arm from the wiper mounting arm and pivot shaft assembly.
    Fig 1: Locating Wiper Motor Linkage Arm
    G06271588Courtesy of FORD MOTOR CO.
  4. Remove the 2 wiper motor-to-wiper mounting arm bolts and the wiper motor.
    • To install, tighten to 8 Nm (71 lb-in).
  5. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals