Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.

Remove the wiper pivot arm cap.

Fig 1: Locating Wiper Pivot Arm Cap
Courtesy of FORD MOTOR CO.
Remove the wiper pivot arm retaining nut and the wiper pivot arm.
- To install, tighten to 20 Nm (177 lb-in).
Fig 2: Locating Wiper Pivot Arm Retaining Nut
Courtesy of FORD MOTOR CO.
To install, reverse the removal procedure.