LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2339 (Anti-Lock Brake System - Vehicle Dynamic Systems) >> Removal And Installation >> Steering Wheel Rotation Sensor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2010 Mercury Milan, 2010 Lincoln MKZ, and 2010 Ford Fusion. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the steering column shroud. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Disconnect the steering wheel rotation sensor electrical connector.
  3. Remove the 2 bolts and the steering wheel rotation sensor.
  4. To install, reverse the removal procedure.
    • Using the scan tool, calibrate the new steering wheel rotation sensor to the ABS module. Follow the scan tool instructions for Interactive Vehicle Dynamics (IVD) Initialization.
scientia non olet · About LEMON Manuals