LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2172 (Drum Brake System) >> Removal And Installation >> Brake Drum >> Installation

Brake Drum: Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the special tool, measure the inside diameter of the brake drum.
    • Install a new brake drum if the inside diameter exceeds the specification stamped on the outside face of the brake drum.
    2. Fig 1: Measuring Inside Diameter Of Brake Drum
    GF0024646Courtesy of FORD MOTOR CO.
  2. Adjust the rear brakes, refer to Brake Shoe Adjustment .
  3. Position the brake drum on the vehicle.
  4. Install the wheel and tire. For additional information, refer to WHEELS AND TIRES article.
scientia non olet · About LEMON Manuals