LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2152 (Engine - 2.3L - (Except Hybrid)) >> In-Vehicle Servicing >> Oil Pump Screen and Pickup Tube >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING AND LIFTING article.
  2. Remove the oil pan. For additional information, refer to Engine Lubrication Components - Exploded View  and Oil Pan .
    3. NOTE: Discard the gasket and clean and inspect the gasket mating surfaces.
  3. Remove the 2 bolts and the oil pump screen and pickup tube.
    • To install, tighten to 10 Nm (89 lb-in).
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals