LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 2109 (Sunroof) >> Removal And Installation >> Roof Opening Panel Shield >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the roof opening panel glass. For additional information, refer to Roof Opening Panel Glass .
  2. Remove the 2 roof opening panel drain channel screws and the drain channel.
  3. Remove the roof opening panel shield.
    1. Disengage the 4 spring-loaded slide locks.
    2. Slide the panel up and forward.
    4. Fig 1: Roof Opening Panel Shield & Spring-Loaded Slide Locks
    GF0023898Courtesy of FORD MOTOR CO.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals