Roof Opening Panel Glass
WARNING: This page is about a different car, the 2008 Mercury Mariner and 2008 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
- Open the roof opening panel to the VENT position.
- Remove the 4 roof opening panel glass screws and the roof opening panel glass.
- To install tighten to 5 Nm (44 lb-in).
- To install, reverse the removal procedure.
- Verify that the roof opening panel is centered and aligned before tightening the bolts. For additional information, refer to Roof Opening Panel Alignment .