LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1962 (Parking Brake System & Actuation -- F250-F550 Super Duty) >> Removal And Installation >> Parking Brake Control >> Removal And Installation

Removal And Installation

WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release the tension on the parking brake system. For additional information, refer to Parking Brake Cable Tension Release  in this article.
  2. Disconnect the parking brake switch electrical connector.
    Fig 1: Locating Parking Brake Switch Electrical Connector
    GF0006714Courtesy of FORD MOTOR CO.
  3. Disconnect the parking brake release handle cable and conduit from the parking brake control.
    Fig 2: Locating Parking Brake Control
    GF0006715Courtesy of FORD MOTOR CO.
  4. Remove the 3 parking brake control retaining nuts and position the parking brake control aside.
    • To install, tighten to 25 Nm (18 lb-ft).
  5. Disconnect the hood release cable from the hood release handle.
  6. Position the parking brake cable and conduit grommet through the floor pan and remove the parking brake control.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals