Inspection and Verification
WARNING: This page is about a different car, the 2007 Ford Pickup, 2007 Ford F550 Super Duty, 2007 Ford F450 Super Duty, and 2007 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
- Road test.
- Verify the customer's concern by carrying out a road test on a smooth road. If any vibrations are apparent, refer to NOISE, VIBRATION AND HARSHNESS article.
- Inspect tires.
- Check the tire pressure with all normal loads in the vehicle and with the tires cold. For additional information, refer to the vehicle certification (VC) label.
- Verify that all tires are sized to specification. Refer to WHEELS AND TIRES article.
- Inspect the tires for incorrect wear and damage. Refer to WHEELS AND TIRES article.
- Inspect chassis and underbody.
- Remove any excessive accumulation of mud, dirt or road deposits from the chassis and underbody.
- Inspect for aftermarket equipment.
- Check for aftermarket changes to the steering, suspension, wheel and tire components (such as competition, heavy duty, etc.) The specifications shown in this manual do not apply to vehicles equipped with aftermarket equipment.
VISUAL INSPECTION CHARTMechanical - Front wheel bearing(s)
- Loose or damaged front or rear suspension components
- Loose, damaged or missing suspension fastener(s)
- Loose or damaged leaf spring shackle(s)
- Incorrect spring usage
- Damaged or sagging spring(s)
- Damaged or leaking shock absorber(s)
- Worn or damaged suspension bushing(s)
- Loose, worn or damaged steering system components
- Damaged axle components
- If an obvious cause for an observed or reported condition is found, correct the cause (if possible) before proceeding to the next step.
- If the fault is not visually evident, determine the symptom. Go to Symptom Chart .