LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1831 (Exterior Lighting System) >> Diagnostic Tests >> Headlamps >> Inspection and Verification

Inspection and Verification

WARNING: This page is about a different car, the 2007 Lincoln Mark LT and 2007 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Verify the customer concern.
  2. Visually inspect for obvious signs of mechanical or electrical damage.
    VISUAL INSPECTION CHART

    Mechanical Electrical
    • Headlamp switch
    • Multifunction switch
    • Vehicle security module (VSM)
    • Central junction box (CJB) fuse(s):
      • 23 (10A) (RH low beam)
      • 25 (10A) (LH low beam)
      • 35 (20A) (high beams)
      • 40 (20A) (headlamp switch)
    • High beam relay
    • Daytime running lamp (DRL) enable relay (if equipped)
    • Circuitry
  3. If an obvious cause for an observed or reported concern is found, correct the cause (if possible) before proceeding to the next step.
  4. If the concern is not visually evident, verify the symptom. Go to Symptom Chart .