LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1784 (Engine Controls - Powertrain DTC Charts And Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> P0607 - Control Module Performance

P0607 - Control Module Performance

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P0607 - CONTROL MODULE PERFORMANCE

Description:  Indicates that the powertrain control module (PCM) internal central processing unit (CPU) has encountered an error. The PCM monitors itself and carries out internal checks of its own CPU. If any of these checks returns an incorrect value, the DTC is set.
Possible Causes: 
  • Module programming error
  • Aftermarket performance products
  • Damaged PCM
Diagnostic Aids:   
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All Reprogram or update the calibration. Check for other DTCs or drive symptoms for further action. Make sure to check for aftermarket performance products before installing a new PCM. If it is necessary to install a new PCM, refer toFLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) .
scientia non olet · About LEMON Manuals