LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1784 (Engine Controls - Powertrain DTC Charts And Descriptions (Except Diesel & Hybrid)) >> DTC Diagnosis >> P0602 - Powertrain Control Module (Pcm) Programming Error

P0602 - Powertrain Control Module (Pcm) Programming Error

WARNING: This page does not describe the selected car, but rather 32 other vehicles, including the 2007 Mercury Mountaineer, 2007 Mercury Monterey, 2007 Mercury Montego, 2007 Mercury Milan, and 2007 Mercury Mariner. However, it is still accessible from the selected car via links, so may be relevant.
P0602 - POWERTRAIN CONTROL MODULE (PCM) PROGRAMMING ERROR

Description:  This DTC indicates a programming error within the vehicle ID (VID) block.
Possible Causes: 
  • VID data corrupted by the scan tool during VID reprogramming
Diagnostic Aids:  Using the scan tool, reprogram the VID block. If the PCM does not allow reprogramming of the VID block, reflashing of the PCM is required.
Application  Key On Engine Off  Key On Engine Running  Continuous Memory 
All The VID block must be programmed. Refer toFLASH ELECTRICALLY ERASABLE PROGRAMMABLE READ ONLY MEMORY (EEPROM) .
scientia non olet · About LEMON Manuals