LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1655 (Rear Drive Axle/Differential) >> In-Vehicle Repair >> Drive Pinion Flange and Drive Pinion Seal >> Installation

Drive Pinion Flange and Drive Pinion Seal: Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using the special tool, install a new drive pinion seal.
    Fig 1: Identifying Special Tool
    G04655389Courtesy of FORD MOTOR CO.
  2. Install the drive pinion flange.
    Fig 2: Installing Drive Pinion Flange
    G04655390Courtesy of FORD MOTOR CO.
  3. Install a new drive pinion flange nut.
    • Tighten to 100 N.m (74 lb-ft).
    Fig 3: Installing New Drive Pinion Flange Nut
    G04655391Courtesy of FORD MOTOR CO.
  4. Install the driveshaft assembly. For additional information, refer to REMOVAL AND INSTALLATION .
scientia non olet · About LEMON Manuals