LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1653 (Transfer Case - Power Transfer Unit (PTU)) >> In-Vehicle Repair >> Output Flange >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Montego, 2006 Ford Freestyle, and 2006 Ford Five Hundred. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the driveshaft. For additional information, refer to REMOVAL AND INSTALLATION .
  2. Remove the output flange nut.
    • To install, tighten to 100 N.m (74 lb-ft).
    Fig 1: Removing Output Flange Nut
    G04657657Courtesy of FORD MOTOR CO.
  3. Remove the output flange.
  4. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals