LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1488 (Anti-Lock Brake System - Vehicle Dynamic Systems) >> Removal And Installation >> Accelerometer - Hybrid >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: The traction battery and charging system contain high voltage components and wiring. High voltage insulated safety gloves and a face shield must be worn when carrying out any diagnostics on this vehicle. Failure to follow these instructions may result in severe personal injury or death.
  1. Disconnect the battery. For additional information, refer to BATTERY DISCONNECT .
  2. Depower the high voltage battery. For additional information, refer to HIGH-VOLTAGE TRACTION BATTERY SYSTEMS DEPOWERING .
  3. Remove the floor console. For additional information, refer to REMOVAL AND INSTALLATION .
    4. NOTE: When installing the accelerometer the electrical connector must face the driver seat.
  4. Disconnect the electrical connector.
  5. Remove the 2 accelerometer nuts.
    • To install, tighten to 7 N.m (62 lb-in).
  6. Remove the accelerometer.
  7. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals