LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1495 (Instrument Panel And Console) >> Removal And Installation >> Console - Floor >> Removal and Installation

Removal and Installation

WARNING: This page is about a different car, the 2006 Mercury Mariner and 2006 Ford Escape. However, it is still accessible from the selected car via links, so may be relevant.

    All vehicles 

  1. Position the seats forward and remove the 2 rear bolts.
  2. Position the seats rearward and disconnect the battery. For additional information, refer to BATTERY, MOUNTING AND CABLES .
  3. Position the parking brake handle to the full-up position.
  4. Remove the transmission selector lever bezel.

    5. Mariner Only 

  5. Remove the floor console top panel.

    6. All vehicles 

    NOTE: On Escape, if removing the floor console storage bin, squeeze the front and rear of the storage bin to release the retaining tabs from the floor console finish panel.
  6. Remove the floor console finish panel.
    • Disconnect the electrical connectors.
  7. Release the parking brake handle boot from the floor console finish panel.
  8. Remove the 6 bolts and remove the floor console.
  9. To install, reverse the removal procedure.
scientia non olet · About LEMON Manuals