Inspection and Verification: Notes
WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
- Verify the customer concern.
- Visually inspect for obvious signs of mechanical or electrical damage.VISUAL INSPECTION CHART
Mechanical Electrical - Door lock mechanisms
- Rear battery junction box (BJB) fuse(s):
- 1 (15A)
- 4 (10A)
- 23 (30A)
- 25 (40A)
- 27 (30A)
- Central junction box (CJB) fuse(s):
- 7 (5A)
- 20 (10A)
- 22 (10A)
- Driver door module (DDM)
- Rear electronic module (REM)
- Front electronic module (FEM)
- Circuitry
- Remote keyless entry (RKE) transmitter
- If the concern remains after the inspection, connect the diagnostic tool to the data link connector (DLC) located beneath the instrument panel and select the vehicle to be tested from the diagnostic tool menu. If the diagnostic tool does not communicate with the vehicle:
- check that the program card is correctly installed.
- check the connections to the vehicle.
- check the ignition switch position.
- If the diagnostic tool still does not communicate with the vehicle, refer to the diagnostic tool manual.
- Carry out the diagnostic tool data link test. If the diagnostic tool responds with:
- SCP circuit fault; all electronic control units no response/not equipped, refer to MODULE COMMUNICATIONS NETWORK .
- No response/not equipped for DDM, refer to MULTIFUNCTION ELECTRONIC MODULES .
- No response/not equipped for REM, refer to MULTIFUNCTION ELECTRONIC MODULES .
- No response/not equipped for FEM, refer to MULTIFUNCTION ELECTRONIC MODULES .
- System passed, retrieve and record the continuous diagnostic trouble codes (DTCs), erase the continuous DTCs, and carry out the self-test diagnostics for the DDM, FEM, or REM.
- If the DTCs retrieved are related to the concern, go to the DRIVER DOOR MODULE (DDM) DIAGNOSTIC TROUBLE CODE (DTC) INDEX , the Front Electronic Module (REM) Diagnostic Trouble Code (DTC) Index, the Rear Electronic Module (FEM) Diagnostic Trouble Code (DTC) Index, or the Switched System Power (SSP) Relay Index to continue diagnosis.
- If no DTCs related to the concern are retrieved, GO to SYMPTOM CHART .