LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1262 (Engine - 3.0L (4V)) >> In-Vehicle Repair >> Valve Spring, Retainer and Seal >> Installation

Valve Spring, Retainer and Seal: Installation

WARNING: This page is about a different car, the 2005 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the valve stem seal.
    Fig 1: Identifying Valve Stem Seal
    G03995837Courtesy of FORD MOTOR CO.
  2. Install the valve spring and retainer.
  3. Using the special tool, compress the valve spring and install the retainer keys.
    Fig 2: Compressing Valve Spring And Install Retainer Keys
    G03995835Courtesy of FORD MOTOR CO.
  4. Release the compressed air used to hold the valves closed.
  5. Install the spark plug for the cylinder being serviced. Do not tighten at this time.
  6. Repeat the appropriate removal and installation steps for all of the other cylinders.
  7. Tighten the spark plug(s) to 15 Nm (11 lb-ft).
  8. Coat the valve tappets with clean engine oil and insert them.
  9. Install the camshafts. For additional information, refer to VALVE TRAIN COMPONENTS - EXPLODED VIEW  and CAMSHAFTS  in this article .
scientia non olet · About LEMON Manuals