Removal & Installation (3.0L & 4.0L)
WARNING: This page does not describe the selected car, but rather 16 other vehicles, including the 2000 Mercury Villager, 2000 Mercury Mountaineer, 2000 Lincoln Navigator, 2000 Ford Windstar, and 2000 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
CMP sensor is located on rear of engine, behind intake manifold. Before removing, note position of electrical connector on CMP sensor. On 4.0L push rod engine, remove upper intake manifold. See REMOVAL & INSTALLATION (4.0L VIN X) under UPPER INTAKE MANIFOLD. On all models, disconnect CMP sensor. Remove CMP sensor screws and CMP sensor. To install, reverse removal procedure. Ensure CMP sensor electrical connector is pointing in original direction. Tighten CMP sensor to specification. See TORQUE SPECIFICATIONS .