LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Supplemental Inflatable Restraint System -- Excursion & F250-550 Super Duty) >> Removal & Installation >> Passenger-Side Air Bag Module >> Installation

Passenger-Side Air Bag Module: Installation

WARNING: This page is about a different car, the 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, 2002 Ford Excursion, and 2002 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
  1. Position passenger-side air bag module in instrument panel opening. Install air bag module mounting bolts. Tighten passenger-side air bag module mounting bolts to specification. See TORQUE SPECIFICATIONS . Install 6 NEW retaining clips on air bag module door. Position air bag module deployment door over air bag module and press on door to seat retaining clips.
  2. Remove air bag simulator from passenger-side air bag module harness connector and reconnect connectors. Connect negative battery cable. With air bag simulators installed at all deployable devices, perform system operation check. See SYSTEM OPERATION CHECK . Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
Fig 1: Removing Passenger-side Air Bag Module
G99F21951Courtesy of FORD MOTOR CO.
scientia non olet · About LEMON Manuals