LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 108 (Supplemental Inflatable Restraint System -- Excursion & F250-550 Super Duty) >> Removal & Installation >> Front Seat >> Installation

Front Seat: Installation

WARNING: This page is about a different car, the 2002 Ford Pickup, 2002 Ford F550 Super Duty, 2002 Ford F450 Super Duty, 2002 Ford Excursion, and 2002 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Front seat anchor bolts must be tightened in specific order.
  1. Position front seat in vehicle. Install front seat anchor bolts (DO NOT tighten at this time). Tighten rear anchor bolts to specification. See TORQUE SPECIFICATIONS . Tighten front anchor bolts to specification. Tighten fifth foot anchor bolt to specification. Install fifth foot trim cover. Remove pretensioner simulator from appropriate connector and reconnect under-seat connectors.
  2. Connect negative battery cable. With air bag simulators installed at all remaining deployable devices, perform system operation check. See SYSTEM OPERATION CHECK . Activate air bag system. See ACTIVATING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
scientia non olet · About LEMON Manuals