LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1059 (Engine Controls - Pinpoint Tests - 6.0L Diesel (99P F450/550)) >> Pinpoint Test AS: Loss of Communication With The Fuel Injection Control Module (FICM) >> Introduction >> Signal function

Signal function

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2005 Ford RV Cutaway, 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.

The FICM requires a 12-volt power source. The FICM receives power from the vehicle batteries through the FICM relay contacts each time the ignition switch is turned to the on position. The powertrain control module (PCM) communicates with the FICM using the controller area network (CAN) protocol. The CAN protocol is an international standards organization (ISO) standard for serial data communication. The CAN protocol standard includes a physical layer using differential transmission on a twisted pair of wires and a data link layer that defines different message types, arbitration rules for bus access, methods for fault detection and fault confinement.

scientia non olet · About LEMON Manuals