LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1059 (Engine Controls - Pinpoint Tests - 6.0L Diesel (99P F450/550)) >> Pinpoint Test AR: Random Misfire Detected >> Test Procedure

Test Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2005 Ford RV Cutaway, 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.
  1. AR1 PRELIMINARY DIAGNOSIS FOR DTC P0300 
    • Retrieve and record all DTCs.
    • Record the freeze frame data.
    • Clear all DTCs.
    • Carry out the continuous self-test.

    Are any DTCs present? 

    Yes No
    For DTC P0300, GO to  AR2.
    For all other DTCs, REFER to DIAGNOSTIC TROUBLE CODE (DTC) DESCRIPTIONS .
    The misfire is intermittent and is currently not active. REFER to SYMPTOM CHARTS - 6.0L DIESEL if a driveability concern exists.
  2. AR2 DIAGNOSTIC TROUBLE CODE (DTC) P0300 
    • Possible causes:
      • fuel concern
      • oil aeration
      • high pressure oil pump malfunction
      • fuel injector(s)
      • mechanical engine failure
      • electrical failure
      • Carry out a visual inspection. Check for loose connections, and damaged or corroded pins. Wiggle the harness, attempting to recreate the fault.

      Are any wiring or terminal concerns present? 

      Yes No
      REPAIR as necessary. CLEAR the DTCs. CARRY OUT the OBD drive cycle. REFER to DIAGNOSTIC METHODS - EXCURSION (6.0L DIESEL) . REFER to DIAGNOSTIC SUBROUTINES - 6.0L DIESEL Performance Diagnostics Chart. CLEAR the DTCs. REPEAT the self-test.