LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.5 L, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 1059 (Engine Controls - Pinpoint Tests - 6.0L Diesel (99P F450/550)) >> Pinpoint Test AQ: Injection Control Pressure Too Low - Engine Cranking >> Introduction >> Signal Function

Signal Function

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2005 Ford RV Cutaway, 2005 Ford Pickup, 2005 Ford F550 Super Duty, 2005 Ford F450 Super Duty, and 2005 Ford Excursion. However, it is still accessible from the selected car via links, so may be relevant.

The injection control pressure (ICP) sensor is a variable capacitance sensor. A 5-volt reference voltage provided by the powertrain control module (PCM) is used by the sensor to produce a linear analog voltage proportional to the hydraulic pressure.

The PCM monitors the ICP sensor signal to control the injection pressure regulator (IPR) duty cycle. The PCM modulates the IPR based on the ICP signal to adjust the injector timing and injection pressure providing optimum fuel delivery at all speed, load, and temperature conditions.

scientia non olet · About LEMON Manuals