Removal and Installation
WARNING: This page is about a different car, the 2005 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
- Depower the supplemental restraint system (SRS). For additional information, refer to SUPPLEMENTAL RESTRAINT SYSTEM .
- Remove the instrument cluster center finish panel. For additional information, refer to INSTRUMENT PANEL AND CONSOLE .
- Lower the tilt steering column to the lowest position.
- If equipped, disconnect the transmission range indicator.
- Push in the clips and disconnect the transmission range indicator.
- Remove the 4 screws and the instrument cluster.
- Disconnect the 2 electrical connectors.
- To install, reverse the removal procedure.
- Download the instrument cluster configuration information from the diagnostic tool into the new instrument cluster. For additional information, refer to MODULE CONFIGURATION .
NOTE:
Prior to removal of the instrument cluster, it is necessary to upload the module configuration information to the diagnostic tool. For additional information, refer to MODULE CONFIGURATION
.