LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.5L V6 - VIN G & L) >> Removal & Installation >> Front Cover >> Installation

Front Cover: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Before installing front cover and NEW gasket, apply sealant at specified areas on cylinder block. See Fig 1. Install front cover bolts/studs in locations shown, and tighten 1/4 turn after front cover contacts cylinder block. Complete front cover tightening procedure following sequence shown. See Fig 2. Tighten to specification. See TORQUE SPECIFICATIONS .
    Fig 1: Applying Sealant To Cylinder Block
    G95E13361Courtesy of FORD MOTOR CO.
    Fig 2: Front Cover Bolt/Stud Tightening Sequence
    G99H03771Courtesy of FORD MOTOR CO.
  2. To complete installation, reverse removal procedure. Tighten remaining bolts/nuts to specification. See TORQUE SPECIFICATIONS . Fill crankcase with oil. Check all fluid levels. Start engine, and check for leaks.
scientia non olet · About LEMON Manuals