LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.5L V6 - VIN G & L) >> Removal & Installation >> Engine >> Installation

Removal & Installation: Engine: Installation

WARNING: This page is about a different variant/trim than selected.
  1. To install, reverse removal procedure. To ensure powertrain alignment is correct, install Powertrain Alignment Gauge (T94P-6000-AH) to left side of engine support bracket and subframe. Use NEW nuts on upper engine support bracket and engine/transaxle support.
  2. Tighten all remaining bolts/nuts to specification. See TORQUE SPECIFICATIONS . Check all fluid levels. Evacuated and recharge A/C system. Start engine and check for leaks.
scientia non olet · About LEMON Manuals