LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.5L V6 - VIN G & L) >> Removal & Installation >> Cylinder Head >> Installation

Cylinder Head: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Position NEW cylinder head gasket on engine block. Install cylinder head using NEW cylinder head bolts. Apply clean engine oil to cylinder head bolt threads. Tighten bolts in reverse order of loosening sequence. See Figure. Tighten bolts to specification. See TORQUE SPECIFICATIONS .
  2. Inspect water crossover "O" rings for wear or damage. Replace "O" rings, if necessary. To complete installation, reverse removal procedure. Tighten bolts to specifications. See TORQUE SPECIFICATIONS . Fill crankcase with oil. Fill cooling system. Check fluid levels. Start engine, and check for leaks.
scientia non olet · About LEMON Manuals