LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.5L V6 - VIN G & L) >> Removal & Installation >> Crankshaft Front Oil Seal >> Installation

Crankshaft Front Oil Seal: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Apply engine oil to new oil seal. Using Front Crankshaft Seal Replacer (T88T-6701-A), and Crankshaft Damper Replacer (T74P-6316-B), install oil seal. Apply Sealant (F4AZ-19562-B) to crankshaft damper keyway before installing damper.
  2. Use crankshaft damper replacer and retaining bolt washer, to install crankshaft pulley. Tighten crankshaft pulley retaining bolt to specification. To complete installation, reverse removal procedure. Tighten remaining bolts/nuts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals