LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 2000 >> Contour SE, 2.0 3, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine - 2.5L V6 - VIN G & L) >> Overhaul >> Cylinder Block Assembly >> Rod Bearings

Rod Bearings

WARNING: This page is about a different variant/trim than selected.
  1. Ensure connecting rod and connecting rod cap are marked with matching cylinder number for reassembly reference. Piston must be installed with arrow toward front of engine.
  2. If clearance cannot be adjusted to standard specification of any bearing, grind crankshaft and use undersize bearings. Tighten connecting rod bearing cap nuts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals