LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 26 (Engine Controls - Adjustments - 2.0L) >> Idle Speed & Mixture >> Idle Speed >> MX-6 & 626 2.0L M/T

MX-6 & 626 2.0L M/T

WARNING: This page is about a different car, the 1995 Mazda MX-6 and 1995 Mazda 626. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect Diagnostic Tester (49-B019-9A0) to data link connector. Set SYSTEM SELECT to position 1 and TEST SWITCH to SELF-TEST, or connect jumper wire between data link connector terminals TEN and GND. See Figure .
  2. Connect tachometer to data link connector terminal IG (-). If idle speed is not within specification, rotate air adjusting screw on throttle body. See IDLE SPEED SPECIFICATIONS  table. Disconnect diagnostic tester or jumper wire from data link connector.
scientia non olet · About LEMON Manuals