LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Manual Transmission Removal & Installation) >> Removal & Installation >> Transmission >> Installation (F150 Pickup)

Installation (F150 Pickup)

WARNING: This page is about a different car, the 1996 Ford Ranger, 1996 Ford Pickup, 1996 Ford F-Super Duty, 1996 Ford Explorer, and 1996 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure mating surfaces and locating dowels are clean and free of burrs. Ensure transmission input shaft splines are clean. Place transmission on transmission jack and position under vehicle.
  2. Raise transmission into position and start input shaft into clutch disc. Align splines on input shaft with splines on clutch disc. Move transmission forward until case seats on locating dowels.
  3. Install bellhousing-to-engine block bolts. To complete installation, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS ("F" PICKUP) . Bleed hydraulic clutch system. See HYDRAULIC SYSTEM BLEEDING . Fill transfer case to bottom of filler hole with Mercon ATF (XT-2-QDX or DDX).
scientia non olet · About LEMON Manuals