Installation (F250, F350 & F350 Super Duty Pickup)
WARNING: This page is about a different car, the 1996 Ford Ranger, 1996 Ford Pickup, 1996 Ford F-Super Duty, 1996 Ford Explorer, and 1996 Ford Bronco. However, it is still accessible from the selected car via links, so may be relevant.
- Using Truck Clutch Alignment Shaft (D79T-7550-A), position clutch disc on flywheel. Position pressure plate assembly on flywheel. Align pressure plate and clutch disc with reference mark, and install retaining bolts.
- On 7.3L diesel and 7.5L models, clean and lubricate pilot bearing, clutch release lever stud and fingers of clutch release shaft. To complete installation, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS ("F" PICKUP) .