LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 181 (Engine Controls - Basic Testing - 2.3L) >> No-Start Diagnosis >> Electronic Ignition (EI) System >> Spark Check

Spark Check

WARNING: This page is about a different car, the 1995 Ford Ranger. However, it is still accessible from the selected car via links, so may be relevant.
  1. Perform self diagnostic QUICK TEST to check for ignition-related fault codes, and repair as necessary. See QUICK TEST in TESTS W/CODES - EEC-V (2.3L) article in the ENGINE PERFORMANCE section. If no fault codes are retrieved, check ignition system wiring harness connectors for corrosion and tight fit. See WIRING DIAGRAMS  . Clean or repair connectors as necessary.
  2. If wiring and connectors are okay, use Neon Bulb Spark Tester (D89P-6666-A) to check for spark at each spark plug wire while cranking engine. If spark is strong and consistent at each spark plug (one spark per crankshaft revolution), ignition system is okay.
scientia non olet · About LEMON Manuals