LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 153 (3.8L V6 - VIN [4]) >> Removal & Installation >> Balance Shaft >> Installation

Balance Shaft: Installation

WARNING: This page is about a different car, the 1995 Ford Windstar. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. Lubricate all components with engine oil before installation. Apply sealant to rear bore plug before installing.
    NOTE: Oversize rear bore plug can be identified by oversize stamped on flat area of plug. Ensure proper size plug is installed.
  2. Ensure all timing marks align. See Figure . Check balance shaft end play. Replace thrust plate if end play is not within specification. See the BALANCE SHAFT SPECIFICATIONS  table.
scientia non olet · About LEMON Manuals