LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 151 (7.5L V8 - VIN [G]) >> Overhaul >> Cylinder Head >> Valve Guides

Valve Guides

WARNING: This page does not describe the selected car, but rather 7 other vehicles, including the 1995 Ford RV Cutaway, 1995 Ford Pickup, 1995 Ford F-Super Duty, 1995 Ford Econoline, and 1995 Ford Cutaway. However, it is still accessible from the selected car via links, so may be relevant.
  1. Valve guides must be reamed for an oversized valve if valve stem-to-guide oil clearance exceeds specification. Refer to CYLINDER HEAD  table under ENGINE SPECIFICATIONS. Valves are available with .015" (.38 mm) and .030" (.76 mm) oversize stems.
  2. If oversized valves or oversized valve stem oil seals are not available, valve guide may be bored out to install a service bushing. Always use reamers in proper sequence (smallest first).
NOTE: Always grind valve seat after valve guide has been reamed or service bushing installed.
scientia non olet · About LEMON Manuals