LEMON Manuals: Even more car manuals for everyone
Home >> Ford >> 1996 >> Aerostar Van Window >> Repair and Diagnosis >> External Pages >> Different car >> Section 140 (Engine - 4.9L 6-CYL - VIN [Y]) >> Removal & Installation >> Crankshaft Rear Oil Seal >> Installation

Crankshaft Rear Oil Seal: Installation

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 1996 Ford Pickup, 1996 Ford Econoline, 1996 Ford Club Wagon, 1996 Ford Cab & Chassis, and 1995 Ford Pickup. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect and clean crankshaft surface. Lightly coat crankshaft and sealing surface of NEW oil seal with engine oil. Place seal in position with lip facing inward, and install seal using Rear Oil Seal Installer (T89T-6701-AH).
  2. Keep installer straight in respect to center line of crankshaft. Seal is properly installed when seal installer contacts cylinder block. Coat threads of flywheel bolts with oil resistant sealer. To complete installation, reverse removal procedure. Tighten bolts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals